I know you all know just how much I loooove
bracelets, both making and
wearing them. So it might surprise you to find out that I haven't shared many bracelet tutorials on my blog. Today I am rectifying that by sharing a quick rhinestone cross bracelet DIY which I did with the little Cheeky Monkeys. Being Christians, the cross holds significant meaning for us, and wearing one in our jewellery is a fun sign of our faith. If wearing a large cross on your wrist is not your thing, then this bracelet is easily adaptable to any other large jewellery connector with a loop on both ends.
Supplies
-
one large rhinestone cross connector, or other large connector (available
here and
here)
- 15-20 8mm glass beads or pearls (depending on your wrist size)
- clear beading elastic, approximately 2-2.5 times the length of your wrist
- gel superglue or jeweller's Hypo Cement
Instructions
1. To prevent bead spills, attach a bead stopper to one end of the elastic. Thread the beads onto the beading elastic.
2. Pass the elastic through the loop on one end of the cross connector. Carefully thread the elastic back through half of your beads, making sure the beads abut right up to the connector loop, but not too tightly.
3. Remove the bead stopper, if using one. Thread this remaining loose end of the elastic through the other end of the cross connector. Pass the elastic back through the remaining beads.
4. Tighten the elastic and loosely tie an overhand knot. Carefully try on the bracelet for size, adding or removing beads as needed.
5. Once the bracelet is the required size, tie two overhand knots on top of each other to secure the bracelet. Make sure to tighten the bracelet so that the beads sit nicely next to the connector, but not too tightly. Dab a drop of glue onto the elastic knot and leave to dry.
6. Once the glue is dry, cut the spare elastic close to the knot and adjust the elastic to hide the knot inside a bead. Now wear your bracelet with pride!
.jpg)
.jpg)
